Services
PLC programmingCondition monitoringSCADA & HMIBuilding automationEnergy managementIoT & electronicsSystem support
Technologies
EVON XAMControlBeckhoff TwinCATSiemens TIA PortalCOPA-DATA zenon
Industries
Machines & plantsPharma & life sciencesEnergy & infrastructureBuildings & services
BlogAbout MiRADA Contact

Services / Condition Monitoring

Condition Monitoring

Condition monitoring instead of downtime. MiRADA captures wear-relevant variables on machines and plants, evaluates them over time and reports deviations before damage occurs.

Condition monitoring describes the supervision of a state parameter in a plant or machine. Vibrations, temperatures, runtimes and similar values are captured automatically in order to detect significant changes that indicate a developing fault. This is the core of predictive maintenance: maintenance happens before something breaks.

What is monitored

Typically these are rotating plants and auxiliary systems: compressors, pumps, electric motors, combustion engines and presses. What matters is not the measuring method alone but the question of which measured value on which machine actually describes the condition. We choose the measuring point so that the result triggers a decision – not so that a curve comes into being.

  • Vibrations at bearings, shafts and gearboxes
  • Temperatures at bearings, distributors and windings
  • Runtimes and load cycles as operating context
  • Structure-borne sound as a supplement to vibration measurement
  • Smallest measurable vibrations with piezo or acceleration sensors

Predictive maintenance instead of repair

Predictive maintenance techniques determine the condition of assets in operation in order to estimate when maintenance work is due. This promises cost savings compared with routine or time-based maintenance, because tasks are only performed when needed. One key point: the timing alone is not enough – the significance only emerges when operating hours and load cycles are recorded as well. Otherwise you see a value, but not whether it deviates from normal operation.

Introduction in four steps

  • Choose the machine: rotating, high failure costs, clear operating hours
  • Define the measured value: vibration, temperature, current or runtime
  • Set up the measuring point and capture the operating state as well
  • Evaluation in SCADA or database, with an alarm to maintenance

When the investment pays off

Condition monitoring is worthwhile where downtime is expensive or where wear should become plannable. On machines with low failure costs, the effort for measurement and evaluation quickly exceeds the benefit. As a rule of thumb: if a downtime costs more than the investment in measuring technology, getting started makes sense.

From data to a decision

A measurement is not yet a benefit. The value emerges in the chain: the sensor delivers, the electronics processes, the system visualises, and operations reacts. That is why we develop this chain as a whole – and integrate the measured values into the same visualisation in which the plant runs. In the end there is a maintenance decision, not just a curve.

When is condition monitoring worthwhile?

When downtime is expensive or wear should become plannable – on compressors, pumps, motors and presses. On machines with low failure costs the effort is usually higher than the benefit.

Which measured values are the most meaningful?

That depends on the machine. Most often vibrations at bearings and gearboxes or temperatures at distributors and windings. What matters is that the value remains comparable over the operating hours – which is why we capture the operating state as well.

Can existing sensors be reused?

Yes, provided they deliver a signal that can be evaluated. It is often the more economical variant to use existing sensor technology and modernise evaluation and communication.

How long until the data is meaningful?

Measurement starts immediately, meaningfulness grows with the history. Trend comparisons need months, a reliable estimate of service life rather one to two years. That is why getting in early is decisive – missing months cannot be reconstructed afterwards.