Services
PLC programmingCondition monitoringSCADA & HMIBuilding automationEnergy managementIoT & electronicsSystem support
Technologies
EVON XAMControlBeckhoff TwinCATSiemens TIA PortalCOPA-DATA zenon
Industries
Machines & plantsPharma & life sciencesEnergy & infrastructureBuildings & services
BlogAbout MiRADA Contact

Services / PLC programming

PLC programming

Control software for machines, plants and industrial processes – structured, maintainable and platform-independent.

A good PLC architecture begins with clear interfaces, modular functions and a maintainable structure. What matters are traceable requirements and a solution that fits the real process – not the other way round.

What PLC programming means to us

Control software is good when it keeps running without the developer. That is why we write programs that describe the process and not the hardware: named function blocks, clear interfaces, separation of process logic and device coupling.

  • Development of control software for machines and plants
  • Adaptation and further development of existing programs
  • Connection of sensors, actuators and fieldbus components
  • Commissioning, troubleshooting and production support
  • Machine operation and robot programming
  • Documentation and long-term maintainability

Languages and control platforms

We program in IEC 61131-3, in C# and – where it makes sense – in a scripting language for tests and commissioning. On the controller side we work with Beckhoff TwinCAT, Siemens TIA Portal and B&R, on the visualisation side with EVON XAMControl and COPA-DATA zenon.

  • IEC 61131-3 for structured logic and motion control
  • C# and high-level languages for complex algorithms and orchestration
  • TwinCAT 3 on Beckhoff hardware and as PC-based control
  • TIA Portal for plants with Siemens components
  • Fieldbuses: Profibus, Modbus TCP/RTU, EtherCAT, CANopen, Beckhoff ADS
  • OPC and SQL interfaces for data exchange with higher-level systems

From test to commissioning

A PLC plant is not finished at the desk. We accompany the way from the simulated machine via the test rig to the running plant – with commissioning, troubleshooting, optimisation and an handover that actually reaches the operating team.

  • Simulation and offline test of the control logic
  • Verification of signal processing and limit values
  • Commissioning at the machine builder or directly at the end customer
  • Troubleshooting and root cause analysis for faults
  • Training of operators and handover of the documentation

Why structure matters

Automation projects are rarely finished along with the plant. Processes change, products are added, plants are extended. Software prepared for these changes reduces downtime – and protects against the most expensive form of surprise: a change that nobody understands any more.

That is why we work with structured programs, named function blocks and a separation of process logic and device coupling. The result is software that a different team can maintain as well.

Do you also program on third-party hardware?

Yes. We develop platform-independently. If an existing controller is technically suitable we work with it – even if it is not our preferred platform.

What does PLC programming cost?

That depends on scope: number of axes and drives, complexity of the process logic, number of higher-level systems and the documentation effort. After the initial technical discussion you receive an estimate that itemises these points.

Do you take over existing programs?

Yes, after a stocktake. We examine structure, faults and extensibility and tell you honestly whether further development is worthwhile or a reimplementation is the better choice.

How long does a typical project take?

It ranges from a few weeks for a single machine to several months for a complete plant with a control system. After the conceptual phase we can estimate effort and schedule reliably.